The Bluesky LED lamp is lightweight, compact and easy to use.
Contain:
- 24W LED lamp for curing gels.
- Piuhan with an EU cap.
- Instructions for use.
USE
Before manicure
Choose a flat surface INDOOR where you can clearly see what you are doing. Make sure you are not in direct sunlight.
Cover your chosen surface to protect it from potential messes.
Take your Bluesky LED bulb and plug it into the wall.
Preparation
Wash and dry your hands well.
Using a Bluesky nail file, file your nails into the shape you want.
Gently buff the surface of the nail with a Bluesky buffer file.
Pay special attention to the cuticle and sides of the nail. These areas are prone to chipping if not properly prepared.
Clean
Use Bluesky cleaning cloths and clean the nail surfaces.
Apply Base Coat
Choose which hand you want to manicure first.
Apply a thin, even layer of Blueskyn Base Coat to all four nails and the thumb. Seal the edge of the nail with the polish, and avoid touching the skin or cuticles.
Harden
Place your hand under the lamp and select a 60-second timer.
After 60 seconds, the lamp will turn off by itself. The base coat is now hardened, but it still has a sticky surface that helps the layers of polish adhere to each other, so avoid touching your nails.
Color gel polish and curing
Apply Bluesky color gel polish in the same way as Base Coat. A thin, even layer, seal the tips of the nails with polish. Avoid getting polish on the skin or cuticles.
Place your hand under the lamp and cure for 60 seconds.
Repeat the above steps until you are satisfied with the color coverage. Usually 2 coats are enough to give a full coverage result.
Top Coat and curing
Apply a thin layer of Bluesky Top Coat to your nails.
Place your hand under the lamp and cure for 60 seconds.
Wipe and admire!
After curing, there is still a sticky layer on the nails, this is normal!
Use Bluesky Cleaning Pads and wipe the surface of the nail to remove the stickiness and you're done!