Bluesky Stamping Set

Bluesky Stamping Set includes 4 stamping plates, a stamper and a scraper.
In addition to the set, you will need some stamping polishes.

The stamp included in the set is made of silicone. Silicone stamps are very delicate and should not be cleaned with nail polish remover or other liquids. The easiest way to clean the stamp is with a roll of duct tape or other tape.
Silicone stamps should not be squeezed or treated roughly.

1. Clean the sticky surface of the gel polish with ready-made cleaning wipes or Cleanser liquid.
2. If desired, you can protect the skin from mess with Bluesky Peel Off Tape.
3. Remove the blue protective film from the stamping plate.
4. Choose your desired pattern and apply gel stamping polish to its edge.
5. Swipe the scaper over the polish and pattern so that the polish spreads over the entire pattern. Remember to press hard enough so that the polish gets into the engravings of the stamping plate.
6. Make sure the stamper pad is clean. The stamper can be cleaned, for example, with tape or lint rollers used for clothes. Clear silicone stampers must not be cleaned with any liquids or similar, as this will melt the silicone.
7. Gently press the stamper pad onto the pattern to lift the pattern from the plate. You can also rock the stamper over the pattern. The pattern may not lift from the plate if the stamper is pressed too hard.
8. Aim the pattern at your desired spot on the nail. Press the stamper onto the nail slightly so that the pattern also adheres to the edges of the nail. If the pattern fails, you can wipe it off with Cleanser and lint-free wipes.
9. Once you are satisfied with your pattern, you can cure the nail under a UV lamp for 2 minutes or an LED lamp for 60 seconds.
10. Once the pattern is cured, do not wipe the tackiness as the pattern is very thin and wiping may remove the pattern. Finish the polish and protect the pattern by adding a layer of gel top coat to the nail. Cure under a UV lamp for 2 minutes or an LED lamp for 60 seconds.

Remember to clean the tools after stamping. The stamper and stamping plate must be cleaned between each stamp. The stamper can be cleaned with tape or a lint roller, and the stamping plate can be cleaned with acetone or Moyra Plate Cleaner.

Notes:

• Avoid keeping products in front of a UV/LED lamp, as the products will cure and spoil. The sun's UV rays also cure the products, so do not do nail polish near a window or outdoors, even on cloudy days.
• If bright streaks are visible in the polish, the product's pigment has separated from the polish, and the bottle must then be shaken thoroughly.
• After curing gel polishes, the surface remains sticky so that the gel layers adhere to each other. The polish has therefore cured correctly despite the sticky surface. If impurities adhere to the sticky surface, they can be removed using cleanser wipes.